Message 1 of 1. Use the command line interface to change into these modes. It is an add up of the following: Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Data mode by default is 8 bit, no parity, one stop bit. To turn it on, do the following: This is just an example.

Uploader: Vizragore
Date Added: 18 July 2009
File Size: 58.39 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 72029
Price: Free* [*Free Regsitration Required]

Then it will be not discoverable and will allow connections only from the paired partner. Most terminal programs by default have what’s called echoing turned off. Remember to configure it to your needs.

AIRcable USB5

Solution Tech Specs Support. This is a one time slave command for 11 seconds. Port opened by process. The command line interface is a collection of the simple, most common Bluetooth commands. Display the baud rate of the UART after a connection has been established. After that the devices is in manual mode again. seriwl

[PATCH][RFC] Add AIRcable USB Bluetooth Dongle Driver []

You should understand Bluetooth before you use the manual mode. Specify the maximum sniff interval for slave connections. At this time the two devices will srrial each other, pair, and establish a connection.

  LUCENT QUADRABUS USB OPEN HOST CONTROLLER DRIVER DOWNLOAD

No other device can connect to either AIRcable while the two AIRcable devices have a [paired] connection to one another.

The main advantage of this mode is that it allows several devices to connect to it as opposed to the Cable Mode which is point-to-point and allows only one connection. Do this on both devices that are going to be paired.

This power supply seriak only be used with AIRcable Serial devices. This is our first WiFi product.

AIRcable – Bluetooth-to-Serial

The AIRcable Serial5X has a rechargeable lithium polymere battery build-in and a range of m with our specifically optimized 4 inch antenna. On one device press the pairing button again short click to change the mode to master. Set the baud rate while connected to this value. It allows the discovery of other devices, pairing, inbound slave and outbound master connections, and disconnect by software. Do an inquiry scan for default 11 seconds.

Each module has a button accessible through a hole in the device which is used to pair two modules that become a point-to-point Wireless Cable TM. See power plug information.

I have the drivers loaded correctly per the manufactuer and have verified that I am using the correct drivers. We’d appreciate your feedback. If I use Labview to write the opposite way ie from the port nortmally connected to the end device, I can send commands no problem. It uses the PIN number configured.

  INTELR 537EP DATA FAX MODEM DRIVER DOWNLOAD

The power light will go out briefly. The AIRcable Serial can be set into various advanced modes.

It is an add up of the following: Press and hold the pairing button for 5 seconds. The process will take a few seconds during which the AIRcable will not seria to any commands. Order this if you need an external power supply and cannot provide power to the AIRcable Serial modules through pin 9 of the DB9 connector.

In cable-mode, two AIRcable seroal are paired together and create a connection with one another so no other device can interfere. Preconfigured and Ready for Action. Any help, ideas would be greatly appreciated!